JLCooper ES-SloMoJ - Manual (Page 44)

Time, StartTime and EndTime are 11 digit ASCII values
that specifies timecode values in the following format:
hh:mm:ss:ff
n
1
and n
0
define play speed for the clip in CuePlyStop Slo
mode. The actual play speed is can be determined by the
following equation.
0
2
32
1
256
10
n
n
TapeSpeed
2
32
2
32
1
1 1
10 10
n n
These are the same values sent from the ES-SloMoJ to a machine
and are defined on page 17 of the Sony document Protocol of
Remote (9-pin) Connector 2
nd Edition.
The ‘@’ character terminates the sending of cue data.
When sending data from a computer, a 30 mS delay must be
inserted between each cue to allow the unit to write to nonvolatile
memory. The ES-SloMoJ performs this when it sends data.
For details on how to connect two ES-SloMoJ controllers together
or to connect your ES-SloMoJ to a computer, refer to the pinout
section.
44