JLCooper ES-SloMoJ - Manual (Page 35)

Gangway16 Operation
When Gangway16 Operation is enabled in the menu, the ES-
SloMoJ is able to remotely control the Gangway16. The ES-
SloMoJ must have version 1.23 or later firmware to control the
Gangway16. The Gangway16 requires version 1.01 firmware or
later to be controlled by the ES-SloMoJ.
Firmware upgrades are available for purchase from the
JLCooper Electronics Service Department. You can contact the
Service Department by dialing (310) 322-9990 in North America
or +1-310-322-9990 outside North America. The Service
Department is also available by email at: [email protected].
Setup
To use the Gangway16 with the ES-SloMoJ:
1. Connect port 1 of the ES-SloMoJ to the rear panel controller
port of the Gangway16 as shown below.
35