Gasboy VT 520 User Manual
Page 12
VT 520 Terminal Setup
Page 12
MDE-4974A Boundless® VT 520 Terminal and Okidata® Printer Setup for Gasboy® Fuel Management Systems · October 2012
• If you have a Site Controller II* or Islander II* software version 1.0F or later, then you
may set the Print mode parameter to Normal and configure the DIRECT PRINTOUT
CHANNEL in SYS_PAR to AUX-0.
Note: This parameter combination sends the direct printout to the Okidata logger and it is
not seen on the CRT screen. Any commands performed at the CRT are not logged
unless either output is directed to the logger (using ;>log with the command) or if
you press CTRL and PRINT SCREEN simultaneously to toggle the Main port
output to the logger (the message line at the bottom of the CRT screen toggles
between Printer: Ready and Printer: Auto Print, when these keys are pressed).
*If the Okidata printer is connected directly to the Site Controller II or Islander II, then
configure the DIRECT PRINTOUT CHANNEL in SYS_PAR to the port to which the printer is
connected and for proper connection (RS-232), refer to Site Controller II or Islander II
Installation Manual.
11
Use the arrow keys to highlight the Printer X Serial print speed option. Select 9600 baud
and press ENTER (see
Figure 9: Serial Print Speed Option