Gasboy Dorio 10 - Manual (Page 7)

MDE-4611 Dorio 10 Terminal/Okidata® Printer Setup Instructions • October 2006 Page 7
Set Up Dorio 10 Terminal
7 Use the arrow keys to highlight the Printer Printer mode item.
8 Set the Print mode parameter to the correct parameter setting for your software version:
• If you have a Site Controller I, Islander I, Site Controller II* or Islander II* below
software version 1.0F, Series 1000, TopKAT or "A" System, the Print mode parameter
must be set to Autoprint.
Note: In Autoprint, the Okidata printer will act as a logger and will also print everything
done in command mode. To temporarily suspend output to the printer, press CTRL
and PRINT SCREEN simultaneously (the message line at the bottom of the CRT
screen will toggle between Printer: Ready and Printer: Auto Print when these
keys are pressed). Press CTRL and PRINT SCREEN simultaneously to resume
output to the printer.
• If you have a Site Controller II* or Islander II* software version 1.0F or above, set the
Print mode parameter to Normal and configure the DIRECT PRINTOUT CHANNEL in
SYS_PAR to AUX-0.
Note: This parameter combination sends the direct printout to the Okidata logger and it
is not seen on the CRT screen. Any commands entered at the CRT will not be
logged unless either output is directed to the logger (using ;>log with the
command) or if you press CTRL and PRINT SCREEN simultaneously to toggle
the Main port output to the logger (the message line at the bottom of the CRT
screen will toggle between Printer: Ready and Printer: Auto Print when these
keys are pressed).
* If the Okidata printer is connected directly to the Site Controller II or Islander II,
configure the DIRECT PRINTOUT CHANNEL in SYS_PAR to the port to which the
printer is connected and consult the Site Controller II or Islander II Installation Manual
for proper connection (RS-232).
Display
Terminal type
ASCII emulation
Keyboard
Communication
Modem
Tabs...
Set-up language
On-line
Save settings
Restore settings
Exit Set-Up 5
Printer
Actions
Port select
Printer type
DEC/ISO char sets
PC character sets
Print extent
Print terminator
Print mode
Serial speed print
2-way communication
Transmit flow control
Receive flow control
Word size
Parity
Stop bits
Autoprint
Controller
Normal