Set up okidata microline 184/186 printer, Setting printer switches, Set the printer switches as follows – Gasboy Dorio 10 User Manual
Page 10
Set Up Okidata Microline 184/186 Printer
Page 10
MDE-4611 Dorio 10 Terminal/Okidata® Printer Setup Instructions • October 2006
Set Up Okidata Microline 184/186 Printer
Setting Printer Switches
To prepare the Okidata Microline 184/186 printer for operation with the Boundless Dorio 10
terminal and your Gasboy Fuel Management System, perform the following steps.
1
Install and complete the setup of the printer as specified in the manufacturer's setup
instructions.
2
Set the printer switches as follows:
Switches SW1-1 through SW1-8
SW1
Set to
Function
SW1-1
ON
Parity: Odd
SW1-2
ON
Parity: Without
SW1-3
ON
Data bits: 8
SW1-4
OFF
Protocol: XON/XOFF (Series 1000 V8.1 or higher, FleetKey V2.1 or higher, CFN, or TopKAT)
ON
Protocol: Ready/Busy (Series 1000 versions prior to V8.1, FleetKey versions prior to V2.1,
and “A” systems)
SW1-5
ON
Test select: Circuit
SW1-6
ON
Mode select: Print
SW1-7
ON
Busy line selection: DTR - Pin 20
SW1-8
ON
Busy line selection: DTR - Pin 20
Switches SW2-1 through SW2-3
Baud Rate*
SW2-1
SW2-2
SW2-3
9600
OFF
ON
ON
2400
OFF
OFF
ON
1200
ON
ON
OFF
300
ON
OFF
OFF
* Any change made to the Baud Rate here must
be matched by a corresponding change to the
Boundless terminal Setup, Print Serial print
speed parameter.
Switches SW2-4 through SW2-8
SW2
Set to
Function
SW2-4
ON
DSR output signal: Active
SW2-5
ON
Buffer threshold: 32 bytes
SW2-6
OFF
Busy signal timing: 1 sec (minimum)
SW2-7
ON
DTR signal: Space after power on
SW2-8
OFF
Not used