Gasboy 900 Series - Manual (Page 8)

Installing TopKAT Series 900 Replacement Report Printer Kit
Page 8 MDE-5061 TopKAT™ Series 900 Replacement Report Printer Kit (M11810K001) Installation Instructions · March 2013
14 Turn on the power and check for 24 V between Ground (GND) and Printer Voltage (VP) on
the new Printer Controller PCA [M11960A001 (see
Figure 5 )]. Adjust the supply to 24 V by
turning the potentiometer located on the upper left corner of the printer power supply. Turn
clockwise to increase the voltage and counter-clockwise to decrease the voltage.
Figure 5: Installing New Printer Controller PCA
GND Test Point
VP Test Point
15 Reinstall the power supply cover and secure it with the three screws removed in step 7 on

page 5 .
16 To load the paper, push Paper Pressure Level towards the front of the TopKAT unit (see

Figure 6 ), feed the paper about 3 inches into the paper slot, and then pull the Paper Pressure
Level back to the closed position.
Figure 6: Loading the Paper
Paper Slot
Paper Roll
Paper Path
(ii) (i)
Paper Pressure Level