Gasboy 900 Series - Manual (Page 5)

MDE-5061 TopKAT™ Series 900 Replacement Report Printer Kit (M11810K001) Installation Instructions · March 2013 Page 5
Installing TopKAT Series 900 Replacement Report Printer Kit
Installing TopKAT Series 900 Replacement Report Printer
Kit
To install the TopKAT Series 900 Replacement Report Printer Kit, proceed as follows:
1 Unlock and open the front and rear doors of the TopKAT unit.
2 Turn off the AC power switch located to the right when viewed from the rear of the head.
3 On the front bezel, disconnect all cables to the existing Report Printer Assembly.
4 Remove and retain the four screws securing the existing printer/bracket to the bezel.
5 Remove the existing Printer/Bracket Assembly.
6 Install and secure the new Printer Assembly provided in the kit using the fours screws
removed in step
4 .
Notes: 1) Ensure to align the new Printer Assembly with the four screw holes.
2) The Spacer (Q10213-25) provided in the kit is required under the lower left corner of
the new bracket.
Figure 1: Installing New Printer Assembly
Screws (4X)
Spacer
(Q10213-25)
(i)
(ii) Screws (4X)
Printer Assembly
7 Remove the power supply cover marked WARNING HIGH VOLTAGE by removing the three
screws that secure the cover.