Installation of the 9800a/2600a pump interface kit – Gasboy 9800A User Manual
Page 5
MDE-4863 Gasboy® 9800A or 2600A Pump Interface Kits Installation Instructions · October 2009
Page 5
Installation of the 9800A/2600A Pump Interface Kit
Installation of the 9800A/2600A Pump Interface Kit
Installing these kits involves DC wiring to the Fuel Management System. Read the MDE-4341
Series 9800A/9800Q Pump and Dispenser Installation/Operation Manual and your Fuel
Management System Installation Manual before you proceed. Also refer to
on
and
on
To install the Pump Interface Kits, proceed as follows:
1
Turn off the Circuit Breakers that supply power to the MICRO, LIGHTS, and FEED.
2
Unlock and remove the front panel.
Figure 1: Unlocking the Front Panel
Unlock
3
Remove the two bolts located over the tabs of the Bezel Assembly. Lift the Bezel Assembly
upwards and out to remove.
Figure 2: Removing the Bolts on the Front Panel
Bolts