Gasboy 9800A - Manual (Page 11)

MDE-4863 Gasboy® 9800A or 2600A Pump Interface Kits Installation Instructions · October 2009 Page 11
Pulse-out I/F Board (M06587A001) Jumper Settings
Figure 8 illustrates the proper output for using a Pump I/F Board (M06587A001), jumpered to
provide two isolated pulse outputs from a single Pulser (C07357 kits). This option is available
only for 9800A or 9800Q single pumps/dispensers.
Figure 8: Dual-channel, Single-hose Pulse-out I/F
Note: 1) All wiring and conduit runs must conform with all building/fire codes, all Federal,
State, and Local codes, National Electrical Code, (NFPA 70), NFPA 30, and
Automotive and Marine Service Station Code (NFPA 30A) and regulations. Canadian
users must also comply with the Canadian Electrical Code.
2) Refer to MDE-4341 Series 9800A/9800Q Pump and Dispenser Installation/Operation
Manual for complete installation instructions.