Gasboy 9820 - Manual (Page 5)

MDE-4864 Gasboy® 9820 Pump Interface Kit Installation Instructions · October 2009 Page 5
Installation of the Gasboy 9820 Pump Interface Kit
Installation of the Gasboy 9820 Pump Interface Kit
Installing this kit involves DC wiring to the Fuel Management System. Refer to MDE-4567
9120K & 9820K Series AST Pumps Installation and Operation Manual, and your Fuel
Management System Installation Manual before proceeding.
To install the Gasboy 9820 Pump Interface Kit, proceed as follows:
1 Turn off the circuit breakers that supply power to the MICRO and PUMP feeds.
2 Unlock the door and loosen the two screws. Tilt the top of the door out, then lift up to remove
it.
Figure 1: Removing the Door
Loosen the Screws
Unlock
the
Door