Gasboy Ultra-Hi Mech Totalizer Kit User Manual
Introduction, Required reading, Required tools
Table of contents
Document Outline
- Introduction
- Important Safety Information
- Installing the Mechanical Totalizer Kits M06943KXXX
- Preparing for the Installation
- Installing the Mechanical Totalizer Kits
- 1 Unlock and remove the lower panel.
- 2 Remove the existing hardware from the totalizer window.
- 3 Assemble and install the new totalizer assembly with the existing hardware, as shown in Figure 1.
- 4 Install the cable assembly with the Spirol pin to the odometer assembly.
- 5 Install the other end of the cable assembly (with larger mounting hole) to the existing meter with the Cotter pin, as shown in Figure 2.
- 6 Attach the tie-wraps around the plastic cable cover and the conduit.
- Completing the Installation