Gasboy Ultra-Hi Mech Totalizer Kit - Manual

MDE-4568 Atlas Ultra-Hi Mechanical Totalizer Kit Installation Instructions · April 2006 Page 1
Introduction
This document explains how to install the totalizer and cable in Atlas ™ Ultra-Hi (Series
9850K) pumps and dispensers. The available mechanical totalizer kits are listed in Available
Kits . Refer to the Parts List table to determine the contents in each kit. Ensure that you follow
all warnings and safeguards as outlined in the Important Safety Information section before
working on the unit.
Required Reading
Before installing a kit, the installer must read, understand, and follow:
• This manual
• NFPA 30A, The Automotive and Marine Service Station Code
• NFPA 70, The National Electric Code
• Applicable federal, state and local codes and regulations
Failure to do so may adversely affect the safe use and operation of the equipment.
Note: This kit must be installed by a Gasboy Authorized Service Contractor (ASC) to ensure
warranty.
Required Tools
The following tools are required to install the totalizer in kits:
• Wrench Set
• Flat tip screwdriver
• Cross tip screwdriver
• Punches (to remove and install pins)
Available Kits
Description Kit Number Quantity Per Meter
Mechanical totalizer kit, Gallons,
9-digit, Atlas Ultra-Hi M06943K001 1
Mechanical totalizer kit, Liters,
9-digit, Atlas Ultra-Hi M06943K002 1
MDE-4568
Atlas ™ Ultra-Hi Mechanical Totalizer Kit
Installation Instructions
April 2006