Gasboy Atlas Rain Baffle Air Gap Kit User Manual
Introduction
Table of contents
Document Outline
- Introduction
- Important Safety Information
- Installing the Rain Baffle Air Gap Kits
- Preparing for the Installation
- Installing the Rain Baffle Air Gap Kit
- 1 Remove the lower door panel.
- 2 Remove and retain the two M8x16 flanged screws (M00415B009) that hold the lower air gap plate in place. Refer to Figure 6.
- 3 Place the rain baffle air gap plate (M06690B001) on top of the lower air gap plate. Insert the two M8x16 flanged screws (M00415B009), removed in step 2, and tighten them.
- 4 Replace the old lower door panel (refer to Figure 2 on page 3) with the new door panel (refer to Figure 4 and Figure 5 on page 4).
- 5 Repeat steps 1-4 on the opposite side of the unit, if the lower door panel on that side needs to be replaced.
- Completing Installation