Gasboy Atlas Rain Baffle Air Gap Kit User Manual
Introduction

MDE-4548 Atlas™ Rain Baffle Air Gap Kit M06804K002 Installation Instructions • February 2006
Page 1
Introduction
This document provides instructions for installing the rain baffle air gap kits on Atlas
™
electronic models when retrofitting an M06715 lower door panel onto units that previously
used the old style M04256 lower door panels. The M04256 lower door panel comprised a two-
piece construction that provided a separation between the hydraulics and the air gap on
electronic models. The M06690B001 Rain Baffle Air Gap plate provides a rain shield for the
air gap vents and maintains air gap integrity by separating the hydraulics and the air gap when
using the one piece M06715 lower door panels.
Rain Baffle Air Gap Kits
Kit No.
Description
M06804K002
Atlas Rain Baffle Air Gap Kit
Note: The kit must be added to any electronic model that had the 2-piece panel with riveted
air gap grill when changing to M06715 door.
Note: Rain baffle air gap plates are not required for mechanical models. M06715
panels for mechanical models do not have grills and will not fit on units with rain baffle
air gap plates.
!
WARNING
To maintain air gap integrity, all Atlas electronic models must have a rain baffle air
gap plate (M06690B001) on both sides when using an M06715B002, B102, B003,
or B103 lower door panels. M06715B001 or B101 must not be used on an electronic
model.
Required Reading
Before installing a kit, the installer must read, understand, and follow:
• This manual
• NFPA 30A, The Automotive and Marine Service Station Code
• NFPA 70, The National Electric Code
• Applicable federal, state and local codes and regulations
Failure to do so may adversely affect the safe use and operation of the equipment.
Note: This kit must be installed by a Gasboy Authorized Service Contractor (ASC) to ensure
warranty.
Required Tool
Socket wrench 13mm
MDE-4548
Atlas
™
Rain Baffle Air Gap
Kit M06804K002 Installation Instructions
February 2006
Document Outline
- Introduction
- Important Safety Information
- Installing the Rain Baffle Air Gap Kits
- Preparing for the Installation
- Installing the Rain Baffle Air Gap Kit
- 1 Remove the lower door panel.
- 2 Remove and retain the two M8x16 flanged screws (M00415B009) that hold the lower air gap plate in place. Refer to Figure 6.
- 3 Place the rain baffle air gap plate (M06690B001) on top of the lower air gap plate. Insert the two M8x16 flanged screws (M00415B009), removed in step 2, and tighten them.
- 4 Replace the old lower door panel (refer to Figure 2 on page 3) with the new door panel (refer to Figure 4 and Figure 5 on page 4).
- 5 Repeat steps 1-4 on the opposite side of the unit, if the lower door panel on that side needs to be replaced.
- Completing Installation