Formax FD 150 - Manual (Page 46)

Operating Manual
42 1/97
9. Push the COTTER PIN until the AXLE is secured
between the two CLIPS on the COTTER PIN.
8.1.4 Document Jam
If the FD 150 stops feeding, there may be one or more
documents jammed inside the machine. To clear a jam,
follow this procedure:
1. Unplug the POWER CORD.
2. Turn the EXECUTIVE KEY to the UNLOCKED
position.
3. Open the COVER.
4. Remove the PRESSURE TIRE SHAFT by pushing the
spring-loaded end of the PRESSURE TIRE SHAFT
toward the hole opposite the operator’s side. Pull the
other end toward you and out of the machine.
5. Pull any jammed documents out of the FD 150.
6. Push the spring loaded end of the PRESSURE TIRE
SHAFT into hole opposite the operator side.
7. Mate the other end of the PRESSURE TIRE SHAFT
into the d-hole on the operator’s side and release.
8.2 Troubleshooting
Chart
The following Troubleshooting Chart helps you identify
and correct malfunctions. To use the Troubleshooting
Chart:
1. Locate the malfunctions in the trouble column.
2. Read across to the cause column.
3. Follow the instructions given in the remedy column.