Formax FD 150 - Manual (Page 38)

Operating Manual
34 1/97
6.7 Imprinting
Documents
Use the following instructions to imprint documents.
1. Turn POWER SWITCH ON.
2. Turn the EXECUTIVE KEY slowly to the LOCKED
position. (Refer to Figure 6.1.)
NOTE
If the SADDLE HOLDER does not index, turn the
key slower.
3. Check the FEED TRAY to be sure that documents are
loaded properly. Refer to Section 6.2.
4. Check the RECEIVING TRAY to be sure that
MAGNETIC PAPER GUIDES are set properly. Refer
to Section 6.2
5. Press the MEDIA FEED button so its light turns ON.
6. If documents feed straight and regularly, press the
MEDIA FEED button OFF and turn the IMPRINT
KEY to ON.
7. Press the MEDIA FEED button quickly ON and OFF
to feed a single test document.
8. Adjust the imprint position if necessary. Refer to
Sections 6.4 and 6.6.
9. Make Log Book entries and re-set counter.
10. Press the MEDIA FEED button and imprint the rest of
the documents.
NOTE
If you encounter a problem, (i.e. - jammed
documents, wrong imprint position, erratic
feeding, etc.) STOP feeding immediately by
pressing the MEDIA FEED button so its light turns
OFF.