Formax FD 150 - Manual (Page 13)

Operating Manual
1/97 9
5. Hold the INK ROLL between the sides of the INK
ROLL CARRIAGE.
6. Insert the AXLE, pointed end first, through the holes in
the INK ROLL CARRIAGE and the INK ROLL.
7. Insert the straight side of the COTTER PIN into the
hole in the pointed end of the AXLE.
8. Push the COTTER PIN until the AXLE is secured
between the two loops on the COTTER PIN.
9. Close the COVER.
3.3 Receiving Tray,
Temporary
Installation
Use the following instructions to temporarily install the
receiving tray. (Refer to Figure 3.3.)
Figure 3.3 -- FD 150 Receiving Tray Installation
1. Place the FD 150 on a table or work surface about 2"
from the straight edge.
2. Slide the NOTCHES in the tray up under the
MOUNTING STUDS on the output end of the FD 150.