Formax FD 150 User Manual
Page 42
Operating Manual
38
1/97
1. Clean the FD 150 exterior surfaces periodically with a
mild soap cleaner and a cloth. This will help maintain
the appearance and operation of the machine.
NOTE
If you cannot remove ink from the
FD 150 with a
mild soap cleaner, use lemon extract.
√
Tip: Clean ink off your hands with rubbing alcohol or pumice soap.
2. Using compressed air, blow away any dust or debris
from the outside of the FD 150.
3. Open the COVER.
4. Using compressed air, blow away any dust or debris
from the inside of the FD 150. Aim at the photosensors.
NOTE
Do not hold the compressed air can close enough
to the PHOTOSENSORS to freeze them.
5. Clean the FEED ROLL, TRANSPORT ROLLS,
BUMPER WHEEL (which is on the FEED TRAY),
SADDLE HOLDER, IMPRINT SADDLES and the
BACKUP PLATEN with isopropyl alcohol and a cloth.
NOTE
Clean the PRESSURE TIRES with a dry cloth or
dry coarse brush ONLY. Do not clean these rolls
with alcohol or any other liquid cleaner.
6. Close the COVER.
7.3 Replacing
A
Fuse
When one or both FUSES are blown, the FD 150 will
appear to have no power. If the FD 150 has blown a FUSE,
replace the fuse. The FUSE DRAWER is located on the
input end of the machine. Use the following instructions to
replace one or both FUSES. (Refer to Figure 7.3.)