2 cleaning – Formax FD 150 User Manual

Page 41

Operating Manual

1/97

1. Turn the EXECUTIVE KEY to the UNLOCKED

position and open the COVER.

2. Grasp the pressure tires and push the spring-loaded end

of the PRESSURE TIRE SHAFT into the hole opposite
the operator’s side.

3. Pull the d-hole end of the shaft up and out of the

FD 150, removing the shaft.

4. To install, push the spring-loaded end of the

PRESSURE TIRE SHAFT into its hole.

5. Mate the other end of the PRESSURE TIRE SHAFT

into the d-hole on the operator’s side and release.

6. Close the COVER.

7.2 Cleaning

Use the following instructions to clean the exterior and
paper path of the FD 150. Refer to Figure 7.2 throughout
this procedure.

Figure 7.2 -- Under Cover View of the

FD 150 with the

Tire Pressure Shaft Removed