Formax FD 150 - Manual (Page 30)

Operating Manual
26 1/97
6. Align the two straight RECEIVING TRAY
MAGNETIC DOCUMENT STOPS with the PAPER
GUIDES. Center the curved RECEIVING TRAY
MAGNETIC DOCUMENT STOP so it stops and
stacks the exiting documents.
7. Loosen the FEED ADJUST KNOB and lift up the
SEPARATOR.
8. Place one document, face up in the PAPER GUIDES,
atop the FEED ROLLS.
Documents LONGER than 9”
Use the following instructions to imprint documents
longer than approximately 9" (22.86 cm):
• If necessary, install the FEED TRAY
EXTENSION by attaching it to the input end of
the FD 150 FEED TRAY with the knobs
provided.
• Feed the top of the document first.
• Install the REVERSE IMPRINT SADDLES.
Refer to Section 6.1 and follow the instructions
given for IMPRINT SADDLES. Call your
Formax dealer to order these saddles.
9. Lower the SEPARATOR against the document and
tighten the FEED ADJUST KNOB.
10. Now place a stack of documents up to 1½" high, face
up in the PAPER GUIDES.
11. Lower the PAPER WEIGHT to rest on the stack.