Formax FD 150 User Manual

Page 32

Operating Manual

1/97

NOTE

In order to imprint and count properly, documents
must feed through the

FD 150 accurately. If your

FD 150 does not feed documents straight and with
a steady rhythm, call your

Formax dealer for

service.

FD 150 feeding components wear with use

and need periodic replacement.

If multiple documents feed through the FD 150, re-adjust
the gap between the SEPARATOR and the FEED ROLL
by applying slight downward pressure to the SEPARATOR
while tightening the FEED ADJUST KNOB.

If the FD 150 feeds with difficulty, re-adjust the gap
between the SEPARATOR and the FEED ROLL by
tightening the SEPARATOR using the thickness of two
documents instead of one. If feeding does not improve,
refer back to section 6.2, Loading Documents.

6.4 Setting

Imprint Position
UP / DOWN

Use the following instructions to change the imprint
position toward or away from the leading edge of the
document. (Refer to Figure 6.3.)

NOTE

Always imprint several void or test documents
until the imprint position is exactly where you
want it.

1. Turn POWER SWITCH ON.
2. Turn the EXECUTIVE KEY to the LOCKED position

and the IMPRINT KEY ON. (Refer to Figure 6.1.)

NOTE

Turn the EXECUTIVE KEY slowly. If the SADDLE
HOLDER does not index, turn the key slower.