Formax FD 150 - Manual (Page 14)

Operating Manual
10 1/97
3. Re-position the FD 150 so the L-shaped cutout on each
side of the RECEIVING TRAY fits the straight edge of
the table or work surface. The RECEIVING TRAY will
hang off the edge of the table or work surface.
3.4 Receiving Tray,
Permanent
Installation
1. Remove the MOUNTING STUDS with a
1 /
8
" allen
wrench.
2. Place the FD 150 on a table or work surface about 2"
from the straight edge.
3. Place the NOTCHES in the RECEIVING TRAY
against the machine so they surround the holes left after
the MOUNTING STUDS were removed.
4. Re-position the FD 150 so the L-shaped cutout on each
side of the RECEIVING TRAY fits the straight edge of
the table or work surface. The RECEIVING TRAY will
hang off the edge of the table or work surface.
5. Screw the screws (included in the cloth bag) tightly into
these holes.
6. Place the two straight DOCUMENT STOPS in-line
with the PAPER GUIDES. (Refer to Figure 3.4.)
7. Position the curved DOCUMENT STOP so it stops and
stacks exiting documents.
8. To extend the RECEIVING TRAY, pull the tray to the
desired position or length.