Formax FD 150 - Manual (Page 34)

Operating Manual
30 1/97
6.4.1 Imprint Position
Example
Use this example as a guide to understanding the functions
of the IMPRINT POSITIONING controls.
1. Feed a test document through the FD 150 to determine
where the current imprint position is.
2. Measure the distance from the current imprint position
to the desired imprint position. Ex. The distance from
the current imprint position to the desired imprint
position equals 2
3 /
16
" inches.
3. Toggle the IMPRINT POSITIONING LIGHT ON.
4. Press the
↑UP LED twice to move the imprint
approximately 2 inches from its current position.
5. Toggle the IMPRINT POSITIONING LIGHT OFF.
6. Press the
↑UP LED three times to move the imprint an
additional 3 /
16
of an inch (i.e., three 1 /
16
" increments).
7. Press the MEDIA FEED button so its light turns on.
8. Feed a test document through the FD 150 to verify and
fine tune the imprint position.