Formax FD 150 User Manual
Page 22
Operating Manual
18
1/97
SEPARATOR and FEED ROLL. This gap must be
adjusted to allow only one document to feed at a time.
Once the SEPARATOR is in the correct position, tighten
the FEED ADJUST KNOB.
5.5 Imprint
Indicator
The IMPRINT INDICATOR is a red light that turns on
while a document is being imprinted, then turns off until
the next document is imprinted. When the IMPRINT
INDICATOR turns ON, the NON-RESETTABLE and
RESETTABLE COUNTERS both increment.
5.6 Imprint
Key
Two silver IMPRINT KEYS are shipped with the FD 150.
The IMPRINT KEY has two positions: ON and OFF.
(Refer to Figure 5.2.)
Turn the IMPRINT KEY to the ON position to start
imprinting prior to feeding documents. Turn the IMPRINT
KEY to the OFF position to stop imprinting.
5.7 Ink
Adjustment
Knob
Turn the INK ADJUSTMENT KNOB clockwise to make
the imprint darker, counterclockwise to make the imprint
lighter.
NOTE
If you turn the INK ADJUSTMENT KNOB clockwise
as far as it allows and the imprint is still too light
or the COVER starts knocking, the INK ROLL
must be replaced. For best results, the INK ROLL
should just lightly touch the IMPRINT SADDLE.
This will also extend the life of the INK ROLL.