Formax FD 260 - Manual (Page 44)

40
9.2.3 Tab Fold Is
Off Mail Piece
–
Tab Is Tenting
If tabs fold too early so the tab fold is not on the mail
piece, the SWEEP needs adjusting. If the fold
resembles Figure 9.5, the SWEEP position is too
high. If the fold resembles Figure 9.6, the SWEEP
position is too low. The SWEEP is a thin piece of
white plastic that helps fold the tab onto the mail
pieces. It extends below the bottom of the PEEL
PLATE. Adjusting the SWEEP will correct the fold
but should only be done by a trained service
professional.
Figure 9.5 - Sweep Position Too High
Figure 9.6 - Sweep Position Too Low