Formax FD 260 - Manual (Page 18)

14
4.3 Gap Adjustment
Lever
The GAP ADJUSTMENT LEVER on top of the FD
260 tabbing head. (Refer to Figure 4.1.) controls the
size of the gap between the upper and lower feed
rolls.
mail piece thickness: set lever to: Upper feed rolls will:
from
1
/
8
" to
1
/
4
" THICK raise up
thinner than
1
/
8
" THIN Lower down
CAUTION
TO AVOID A JAM, ALWAYS MAKE SURE THE GAP
ADJUSTMENT LEVER IS SET CORRECTLY FOR
THE MAIL PIECES BEING TABBED.
4.4 Tab Size Switch
Toggle between 1.0 and 1.5 inch tabs with the power
OFF. The switch is
located
to the left of the Control
Panel.
Figure 4.2 Tab Size Selector Switch
4.5 Control Panel
Figure 4.3 - FD 260 Control Panel
4.5.1 Tab Ready
The TAB READY light illuminates when a tab is
detected at the peel point. Stray tabs at the peel
point will also illuminate the TAB READY light.