Formax FD 260 User Manual
Page 20

16
4.5.2 Clear Tab
The CLEAR TAB control tells the FD 260 whether to
detect clear (and translucent) or opaque tabs.
When CLEAR TAB is toggled on, the light illuminates
and the sensor is tuned to detect clear tabs. When
CLEAR TAB is toggled off, the light doesn’t illuminate
and the sensor is tuned for opaque (paper) tabs.
NOTE
Before turning CLEAR TAB on, always remove
tabs
or debris from the peel point area.
If there are clear tabs or debris in the peel point area
when CLEAR TAB is activated, the sensor will not
correctly detect clear tabs.
If there are opaque tabs or debris in the peel point
area when CLEAR TAB is activated, the CLEAR TAB
light flashes and neither CLEAR TAB nor ON/OFF
can be activated.
4.5.3 On/Off
The ON/OFF control starts and stops tabbing.
Toggle ON/OFF so the light illuminates to begin
tabbing. Toggle ON/OFF so the light doesn’t
illuminate to stop tabbing.
Once ON/OFF is activated, you cannot change the
CLEAR TAB selection. To change the CLEAR TAB
selection, Toggle ON/OFF off to stop tabbing, remove
tabs and debris from peel point area, turn the
POWER SWITCH off and on again and make your
new CLEAR TAB selection.
NOTE
Once ON/OFF is activated, the CLEAR TAB
selection is locked. Even if you stop tabbing by
toggling ON/OFF off, the CLEAR TAB selection
cannot be changed.