Formax FD 260 - Manual (Page 27)

23
Figure 6.3
– FD 260 Controls
5. Make sure the GAP ADJUSTMENT LEVER is set
properly.
6. Begin feeding mail pieces into the FD 260. The TAB
READY light will illuminate every time a tab reaches the
application point.
7. Make sure each mail piece is tabbed. Re-align the
machines if the tabs are not being placed in the desired
position on the mail pieces. (Also refer to Section 5.1.)
TIP
When finishing a tabbing job, remove the last tab
at the peel point to make the next tabbing job start
off easier:
1. Toggle ON/OFF so light is off.
2. Feed one mail piece through the FD 260
to
remove the last tab at the peel point.