Formax FD 260 - Manual (Page 26)

22
6.2 Feeding
Mail Piece
1. Select Tab Size
2. Turn FD 260
’s POWER SWITCH on.
NOTE
Turn the FD 260
’s POWER SWITCH on before
turning on the feeding device. If the FD 260 is not
turned on first, it will not accept the mail pieces.
3. Toggle ON/OFF so light does not illuminate.
4. Set the FD 260 ’s GAP ADJUSTMENT LEVER to
thick for mail pieces
1
/
8
" to
1
/
4
" thick, or to thin for
mail pieces thinner than
1
/
8
".
4. Place a stack of mail pieces open edge first in the
feeding device. Feed several mail pieces. Adjust
the feeding speed until the mail pieces feed one at
a time with a consistent rhythm.
6.3 Tabbing Mail
Pieces
1. Make sure tabs are threaded correctly and peel
point area is clear.
2. Turn the POWER SWITCH on.
CAUTION
TO AVOID A JAM, TURN THE FD 260 ON BEFORE
TURNING ON THE FEEDING DEVICE.
3. Make CLEAR TAB selection. Toggle CLEAR TAB
on for clear and translucent tabs. Toggle CLEAR
TAB off for opaque tabs.
4. Toggle ON/OFF so the TAB READY light
illuminates.
NOTE
Once the ON/OFF light illuminates, you cannot
change the CLEAR TAB selection.