Formax FD 260 - Manual (Page 40)

36
9.1.4 Torn Backing
Paper
If the backing paper tears before the drive roll, the FD
260 will stop tabbing but continue feeding. To start
tabbing:
WARNING
DO NOT PLACE FINGERS OR TOOLS BETWEEN
OR NEAR MOVING PARTS.
1. Turn the POWER SWITCH off.
2. Thread the FD 260 from the point where the
backing paper tore. (Refer to Section 6.1.)
NOTE
When backing paper is pulled, tabs will peel at the
PEEL PLATE until pulling is stopped.
3. Remove any tabs or debris from the peel point
area through the INSPECTION WINDOW on the
input end, below the threading path.
4. Turn the POWER SWITCH on.
5. Toggle ON/OFF until a tab advances to the peel
point and the TAB READY light illuminates.
If the backing paper tears after the drive roll, the
backing paper may fall away from the FD 260 and
tabbing will continue. If the backing paper wraps
around rolls in the threading path, tabbing may
continue, but tab placement may not be accurate. To
continue tabbing accurately:
WARNING
DO NOT PLACE FINGERS OR TOOLS BETWEEN
OR NEAR MOVING PARTS.
1. Turn the POWER SWITCH off.
2. Secure the backing paper around the TAKE-UP
SPINDLE with the CLIP. You may need to pull the
backing paper a little to reach the TAKE-UP
SPINDLE.