Formax FD 260 - Manual (Page 34)

30
Trouble Cause Solution
7. FD 260 stops. Power entry fuse is
blown.
Replace blown line
fuse. Refer to Section
3.3.
FD 260 keeps blowing
fuses after you replace
them.
Contact authorized
Formax dealer.
Mail piece has jammed
in machine.
Clear the jam. Refer
to Section 9.1.3.
Backing paper has torn
before the drive roll.
Thread tabs from that
point on. Refer to
Section 9.1.4.
8. Feeding stops. Accessory fuse is
blown.
Replace blown
accessory fuse. Refer
to Section 3.4. If the
fuse is not blown,
refer to your feeding
device manual.
9. Backing paper
slack.
Backing paper is
threaded under the
drive roll.
Re-thread tabs. Refer
to Section 6.1.
10. Tabbing
incorrectly
Peel plate assembly is
not latched.
Insert and latch peel
plate assembly.
11. Multiple tabs on
mail piece.
Incorrect CLEAR TAB
selection.
Make CLEAR TAB
selection for tabs
being run. Refer to
Section 9.1.2.
Incorrect Tab Size
setting
Turn Power Off,
change tab size
switch.
12. Tab placement is
inconsistent.
Mail pieces are feeding
crooked.
Make sure mail pieces
feed straight into FD
260. Refer to Section
9.2.1.
Backing paper has torn
after the drive roll.
Re-thread backing
paper from drive roll.
Refer to Section
9.1.4.
13. Tab fold is
uneven.
Peel plate position
needs adjustment.
Adjust peel plate
position. Refer to
Section 9.2.2.
Tab Size Wrong Power Off, select tab
size