Formax FD 260 User Manual

Page 39

CAUTION

PULLING MAIL PIECES IN THE OPPOSITE

DIRECTION THAT THEY MOVE THROUGH THE FD

260 MAY DAMAGE THE SWEEP OR MOVE IT OUT

OF POSITION.

3. If you cannot reach the jammed mail pieces,

continue through the following instructions.

4. Set the GAP ADJUSTMENT LEVER to thick, if it

is set for thin. (Refer to Figure 9.2.)

5. Push the FOAM ROLL ASSEMBLY toward the

end with the spring attached. Pull out the other
end, as you push in the spring end. Make sure the
other end clears the side frame. (Refer to Figure
9.2.)

6. Remove any mail pieces jammed at the feed rolls.

7. Push the spring-loaded end of the FOAM ROLL

ASSEMBLY in its hole in the non-operator side
panel. Place the other end of the FOAM ROLL
ASSEMBLY into the d-hole in the operator side
frame. (Refer to Figure 9.2.)

8. Set the GAP ADJUSTMENT LEVER to thin if you

are tabbing mail pieces thinner than

To remove mail pieces jammed between the belts
and metal rolls at the end of the FEED TRAY:

WARNING

DO NOT PLACE FINGERS OR TOOLS BETWEEN

OR NEAR MOVING PARTS.

1. Turn the POWER SWITCH off.

2. Pull the mail pieces from the feed tray. Make sure

all belts are centered on the metal rolls before you
resume tabbing.