Formax 7200 Series User Manual
Page 51
![background image](https://www.manualsdir.com/files/785543/content/doc051.png)
50
8.5.3 Setting the Separator Gap (see also section 8.2 ‘Adjusting the Sepa-
rator’).
Now set the separator gap to suit the daily mail. As a general guide, the gap should
be set to approx. 1mm greater than the pack or booklet thickness. If the document
is an 80gsm sheet, set the gap to 1mm.
If the thickness is unknown, proceed as follows:
Open the separator gap wide
•
enough to allow the document
to pass through. Insert a
corner of the document
between the separator
wheels as shown - this avoids
snagging the grooves in the
tyres (particularly useful for
thin documents).
Close the separator gap until
•
there is some friction on the
document, then rotate the
separator knob in reverse
direction 1 turn (this will give
clearance of 1mm).
When daily mail has been enabled as described, and the gap has been set, press
the Run button and feed the post into the hopper tray. The machine will wait
for 30 seconds after pressing the button - if you exceed this before inserting the
documents, press the button again.
To turn the function off, switch ‘Daily Mail’ back to No in Document Settings.