Formax 7200 Series - Manual (Page 44)

43
1. Look into the aperture
shown and you will see
the setting gauge on the
side of the separator unit.
There is an 80gsm mark
as a starting point for
single sheets, and mm
settings underneath the 0
line for booklets etc. See
also section 8.5 ‘Daily
Post’.
2. Now adjust the gap as
previously described to
set it precisely.
For problem enclosures, the feed rollers can be changed to optional
alternatives; see section 9.3
 See following page for load capacities of different stationery types.
Note: these are a guideline only - actual quantities may vary. The
label on the side quide will also provide an indication.