Formax 7200 Series - Manual (Page 46)

45
8.3 Loading the flex folder hoppers
The flex folder may be fitted with 500-sheet or 1000-sheet hoppers, or only a single
500-sheet hopper. The example shown has 2 x 500-sheet and 1 x 1000-sheet
hoppers.
1. On 500-sheet hoppers, slacken the black knob next to the side guides (arrowed)
and move the guides to give 1-1.5mm clearance each side.
On 1000-sheet hoppers,
slacken the black knob
above the hopper
(arrowed) and use
the tabs to move the
guides to give 1-1.5mm
clearance each side.
2. Tighten the knobs.
Paper orientation in the hoppers will depend upon the job
requirement - see the paper orientation charts on page 50.
Accumulator
If the flex folder is titted with an optional accumulator, the side guides must be
adjusted to suit the paper.
Raise the top of the accumulator so that
it locks in place and place a piece of
paper between the side guides.
Slacken the black knob next to the side
guides (arrowed) and move the guides
to give 1-1.5mm clearance each side.
Actuate the latch (arrowed) to lower the
accumulator top.