Formax 7200 Series User Manual

Page 28

If you wish to

choose an orientation oth-

er than the auto-selected

default, press Auto to en-

able the selector button.
If required adjust the

degree of deskew, or turn

it off if you require, for ex-

ample if a document type

is found to feed reliably

without skewing.
Thickness doubles can

currently be checked opti-

cally only on a flex folder,

or turned off, if for exam-

ple, documents are sub-

stantially different from

the calibration document,

such as abnormally dark

with heavy printing.

Selecting ‘Auto’ allows the software to choose between optical and mechanical

checking if the document is moved to a versatile feeder fitted with a mechanical

system.
Feed control mode is ‘Feed Always’ as default, but can be turned off to disable the

hopper. It can also e set to ‘Selective Feed’ for reading-enabled units. This works in

conjunction with ‘Item ID’ - see below.
Item ID allows you to define an ID number for the document which accords with

the relevant Select mark in the OMR or Barcode label. This will then feed the docu-

ment when that mark is read.
Sequence handling mode determines how sequence marks (if used) are handled

when a document set is broken up (for example, to change a job in the middle of a

document set). The mode must be det to ‘Full’ for the first pass, and then changed

to ‘Mailset’ for the second pass after the job has been changed. The machine will

not then expect an unbroken sequence.