Formax 6402 Series - Manual (Page 63)

61
ENGLISH
Flap not
sufficiently
moistened. Water level low. Check water level,
refill if needed. “Sealing Envelopes” on
page 26
Brushes dry. Check brushes,
replace if needed by
the extra soaked set. “Sealing Envelopes” on
page 26
Brushes dirty. Check brushes, clean
if needed. “Operator Maintenance”
on page 54
Moistening felt dry. Check the moistening
felt, refill water tray
if needed. “Sealing Envelopes” on
page 26
Moistening felt dirty. Check the moistening
felt, clean if needed.
“Operator Maintenance”
on page 54
Moistening brushes
inactive. Activate the
moistening brushes. “Sealing Envelopes” on
page 26
Brushes worn out. Replace brushes. “Operator Maintenance”
on page 54
Moistening felt worn
out. Replace moistening
felt. “Operator Maintenance”
on page 54
Envelope not
always ejected
from sealer. Inserted document
too big. Check fold settings,
adjust if needed. “Fold Settings” on
page 34
Document not
inserted deep
enough. Check adjustment of
envelope stop
position and fingers. “Insert Position” on
page 28
Sealing area dirty. Clean sealing area. “Operator Maintenance”
on page 54
No document fed. Feeder empty. Refill feeder. “Filling the Document
Feed Tray” on page 24
Separation set too
wide / too tight. Adjust the
separation. “Document Separation”
on page 23
Side guides set too
narrow. Adjust the side
guides. “Side Guides” on
page 23
Skewed
documents fed. Side guides set too
wide. Adjust side guides. “Side Guides” on
page 23
Double
documents fed. Separation set too
wide. Adjust the
separation. “Document Separation”
on page 23
Document
stoppage at
collating area. Stopper position set
incorrect. Adjust stopper
position. “Adjustment of the
Document Stoppers” on
page 24
Symptom Possible cause Remedy Reference