Formax 6402 Series - Manual (Page 49)

47
ENGLISH
Safety Mark
The safety mark is used as an extra security. With
skewed paper the reading head can miss part of the
reading code. In these situations the safety mark is
not read, and the system will give an error.
The safety mark also indicates the end of the
reading code.
This mark must always be present on the document
if it has been activated as an OMR code.
Examples of OMR Code
In the figure the legend for the following example is
shown. In this example feeder station 1 is the
reading feeder. The feeder stations 2 through 6 are
selected for selective feeding.
Example Code
In this example a set of 8 sheets with three selective
feeds (station 2, 3 and 4) and three sequence check
marks is shown.
• The first position is used for the start mark
which must be printed on every sheet.
• The second mark position is used for the insert/
accumulate command. The mark is printed on
the last sheet of the set (inserting is required).
• Position 3, 4 and 5 are reserved for selective
feeding from station 2, 3 and 4. Print a mark on
position 3 when a selective feed from station 2
is required. Print a mark on position 4 when a
selective feed from station 3 is required. Print a
mark on position 5 when a selective feed from
station 4 is required.
• Position 6, 7 and 8 are used for the sequence
check marks.
Normal paper flow Skewed paper flow
Start mark Start mark
Safety mark Safety mark
reading direction reading direction
accumalate
mark printed
no mark printed
insert
no selective feed
wanted, mark not
printed
selective feed
wanted, mark
printed
or
reading feeder 1
selective feeder 2
selective feeder 3
selective feeder 4
selective feeder 5
selective feeder 6
Sheet 1 Sheet 2 Sheet 3 Sheet 4 Sheet 5 Sheet 6 Sheet 7 Sheet 8