Formax 6402 Series - Manual (Page 60)

58
6.2.4 PowerFold
®
When a stoppage occurs in the powerFold
®
, remove
the documents from the powerFold ® as follows:
1. Push the lower end of the locking handle A to
open the powerFold
®
cover B.
2. Remove the documents from the powerFold ® .
3. Close the powerFold
®
cover.
4. Press to reset the error and restart the
job.
6.2.5 FlexFeed
®
When a stoppage occurs in the flexFeed
®
, remove the documents from the flexFeed
®
as
follows:
1. Pull the vertical transport hand grip upward to open the vertical transport cover.
2. Remove the documents.
3. Close the vertical transport cover.
4. Press to reset the error and restart the job.
6.2.6 Collating Area
When a stoppage occurs in the collating area,
remove the documents from the collating area as
follows:
1. Lift and hold the collator arm A.
2. Remove the documents.
3. Lower the collator arm.
4. Press to reset the error and restart the
job.
6.3 Operator Troubleshooting
To resolve problems:
1. Write down the error.
2. Try to solve the problem by consulting the troubleshooting table.
3. Switch the inserter off and on again, to verify system operation.
4. When the error still occurs contact your service organization.
A B
A