Flowserve StarPac II Control Valves - Manual (Page 39)

Integer
Register Attribute Description Notes
40047 RW Scaled setpoint command. Range 0 to 9999, with fixed scale range -
12.5 to 112.5 percent.
40048 RW Scaled digital command. Range 0 to 9999, with fixed scale range -
12.5 to 112.5 percent.
40049 RW Flow type indicator. 0 = Liquid
1 = Gas
40050 RW Positioner signal source selector. 0 = Direct 4-20 mA
1 = Digital
40051 RW Analog command signal state selector. 0 = Normal
4 mA = 0% command
20 mA = 100% command
1 = Inverted
4 mA = 100% command
20 mA = 0% command
40052 RW Loss of analog command signal hold
time. Range 0 to 9999. Seconds
40053 RW Interval between data logger data points. Range 0 to 9999. Seconds
0 = Data logger inactive.
40054 RW Actuator bottom pressure transducer
minimum calibrated ADC value
corresponding to 0 psig. Range -32768 to 32768
40055 RW Actuator bottom pressure transducer
maximum calibrated ADC value
corresponding to supply pressure psig. Range -32768 to 32768
40056 RW Actuator top pressure transducer
minimum calibrated ADC value
corresponding to 0 psig. Range -32768 to 32768
40057 RW Actuator top pressure transducer
maximum calibrated ADC value
corresponding to supply pressure psig. Range -32768 to 32768
40058 RW Minimum ADC value corresponding to
calibrated 4 mA command input. Range 0 to 16384
40059 RW Maximum ADC value corresponding to
calibrated 20 mA command input. Range 0 to 16384
40060 RW Output to I/P. Range 0 to 65535. If system is not in
Calibration mode, writing to this register
will not have an effect.
40061 RW Minimum DAC value corresponding to
0% position. Range 0 to 65535.
40062 RW Maximum DAC value corresponding to
100% position. Range 0 to 65535.
40063 RW Minimum ADC value corresponding to
0 °F ambient temperature. Range -32768 to 32768
StarPac II User Interface Manual 33