Flowserve StarPac II Control Valves - Manual (Page 11)

Status Menu
The S TATUS menu is used to view information about the configuration
and operation of the system. Errors and alarms can also be viewed
from this menu. The S
TATUS menu is arranged as shown in Figure 2.
Err/
Arlm
Row1
Var
Sta-
tus
Row2
Var
Tune Cal-
brat
Con-
fig
Next
Alrm
Set
Sys
Info
View
Reg
Figure 2: Status Menu
Each option may have other menus or options to choose from.
Row 1 and Row 2 Var - Selects the information that will be
displayed on the first two rows of the display during normal
operation. Each selection has the same list of options except where
noted.
Mode/Status - Lists the operating mode and any current alarm
or trip conditions. (This option is only available on Row One.)
Scanning Display - Rotates automatically through a list that is
configured through the user interface. (This option is only
available on Row Two.)
Valve Position - Current valve position in percent open.
(Designated as “Posn” in the display.)
Valve Command - Current valve command in percent open.
(Designated as “Comnd” in the display.)
Liquid Flow - Current liquid flow rate in user-defined units.
(Designated as “FlowQ” in the display.)
Gas Flow - Current gas flow rate in user-defined units.
(Designated as “FlowW” in the display.)
ISA Up Stream Press - Current compensated upstream line
pressure in user-defined units. (Defined as two pipe diameters
upstream of the valve, designated as “P1isa” in the display.)
ISA Dn Stream Press - Current compensated downstream line
pressure in user-defined units. (Defined as six pipe diameters
downstream of the valve, designated as “P2isa” in the display.)
ISA Delta Pressure - Current differential pressure using the
pressure definitions above in user-defined units. (Designated as
“dPisa” in the display.)
Process Temperature - Current process temperature in user-
defined units. (Designated as “Temp” in the display.)
Liquid Flow Totalizer - Totalized liquid flow in user-defined
units. (Designated as “TotlQ” in the display, the totalizer is reset
from the T
UNE menu.)
Gas Flow Totalizer - Totalized gas flow in user-defined units.
(Designated as “TotlW” in the display, the totalizer is reset from
the T
UNE menu.)
StarPac II User Interface Manual 5