equinux Mail Designer Pro 2 - Manual (Page 10)

Adding layout blocks
Click the “Contents” button to open the Contents panel. This contains all the
design elements you can add to your Mail Design. Go to “Layout Blocks”,
choose one and drag it to your design. The other layout sections will slide
out of the way so you can drop in the new layout block.
The other layout blocks will slide out of the way and you can drop the new
layout block into place.
Removing layout blocks
Click the “x” icon on the layout block “handle” to delete a
layout block.
Adding space in-between layout blocks
You'll notice that your new layout block is very close to
the top of the next layout block. This makes the design feel a bit cramped, so
we need to add a bit of space in between the two blocks.
Drag a layout block into your design.
Click “x” to delete
Go back to the Contents panel and drag the spacing layout block in-
between the two content layout blocks.
You can then fine-tune the size of the divider by
dragging the line above or between it - it should look right with about 30
pixels between the two layout blocks.
Duplicating layout blocks
If you are setting up multiple similar layout blocks, it may be easier to dupli-
cate an existing layout block instead of choosing your font and color options
again.
There are two ways you can duplicate layout blocks.
‣ Click the selection tab at the side of a layout block and choose “Edit > Du-
plicate” from the menu bar
We need to add space in-between these two layout blocks
10