Echo Bear Cat 77353-00 - Manual (Page 5)

3 Inch Trailer Instruction Sheet
1
2
If you have an older model chipper/shredder, you will
have to cut off the existing metal leg before installing
the kit. Newer models have a detachable leg. Choose
the instructions below that are appropriate for your
machine
NOTE
BEFORE MOUTING ONTO TRAILER:
MACHINES SERIAL # 707865 TO C03262
1
2
BEFORE MOUNTING ONTO TRAILER:
MACHINES SERIAL # 707807 & BELOW
1. A hoist or other lifting device will need to be used to lift
the machine into place on trailer.
2. The following are the approximate weights of the
chipper/shredders:
SC3265 - 285 lbs. (129.3 kg)
SC3305 - 255 lbs. (116 kg)
SC3305E (w/o battery) - 255 lbs (116 kg)
SC3342 - 255 lbs. (116 kg)
Ensure that the lifting device used is rated and certified to
lift more than the weight of the machine.
3. FOR 3-INCH CHIPPER/SHREDDERS SN 707807 AND
BELOW , cut the leg (1) off with a hacksaw or other
saw appropriate for cutting metal. Make the cut
approximately 1/4" - 1/2" from the chipper frame.
4. Discard metal leg.
5. Remove the three 5/16" nuts (2) and washers.
1. A hoist or other lifting device will need to be used to lift
the machine into place on trailer.
2. The following are the approximate weights of the
chipper/shredders:
SC3265 - 285 lbs. (129.3 kg)
SC3305 - 255 lbs. (116 kg)
SC3305E (w/o battery) - 255 lbs (116 kg)
SC3342 - 255 lbs. (116 kg)
Ensure that the lifting device used is rated and certified to
lift more than the weight of the machine.
3. FOR 3-INCH CHIPPER/SHREDDERS SN 707865 TO
C03262 , remove the metal leg (1) by removing the four
5/16" nuts (2) and washers. Also remove the nut and
washer from the middle lower bolt.
4. Keep and reuse all of the nuts (2) and washers; Discard
the metal leg.