Echo Bear Cat 77353-00 - Manual

3 Inch Trailer Instruction Sheet
1
2
2
3
3
4
5
6
7
8
Instructions
PN 77707-00
Rev. 060113
SUBJECT: TRAILER KIT FOR 3 INCH CHIPPER/SHREDDERS, PART #77353-00
TRAILER VIN: 5VJAA0011DW003952 AND ABOVE
FOR MODEL(S) SC3265, SC3305, SC3305E & SC3342 WITH SN < CO3477 ORDER SUPPLEMENTAL.
KIT, PART # 77700-00
FOR MODEL(S) SC3206 WITH SN < CO3477 ORDER SUPPLEMENTAL. KIT, PART # 77701-00
ATTACH WHEELS (FIGURE 1)
1. Attach wheels to trailer using 3/4"-16 slotted nuts
(1), washers, 5/32" cotter pins (2) and dust caps
(3). Using 3/4" wrench, tighten slotted nut until
resistance is felt when trying to spin wheel. At that
point, back the nut off slightly until slot in nut aligns
with cotter pin hole on axle spindle.
2. Insert cotter pin, bend tabs to secure slotted nut
on spindle and install dust cap.
TRAILER ASSEMBLY INSTRUCTIONS
(FIGURE 2)
1. Place hitch pole (1) into trailer frame. Route trailer light
harness through the two provided coated clamps (2).
2. Now, secure hitch pole to frame using one 3/8 x 3-1/4"
bolt (3), coated clamp, washer and nut at the hole
location detailed in Figure 2 Torque to 28 ft-lbs. Place
1
2
3
Figure 1
Figure 2
3/8" hitch pin (4) in 3/8" hole closest to the trailer.
Also see Figure 2 for location details. This pin can be
removed to allow the hitch to be positioned vertically
for storage purposes. Reinstall pin once the hitch is in
the vertical position.
3. Attach the remaining coated harness clamp (with
harness already routed through it) to hitch pole using
5/16 x 2-3/4" hex bolt (5), washer and nylock nut.
4. Now attach the 2" coupler (6) to the end of the hitch
pole opposite the trailer. Use two 1/2 x 3" bolts (7) and
centerlock nuts.
5. Secure the safety chains (8) to the hitch pole at the
second open hole location behind the coupler. Use the
3/8 x 3-1/4" bolt (3), two washers and one nylock nut.