Echo Bear Cat 77353-00 - Manual

3 Inch Trailer Instruction Sheet
Instructions
PN 77374-00
Rev. 112013
SUBJECT: TRAILER KIT 77353-00 FOR 3 INCH CHIPPER/SHREDDERS
TRAILER VIN: 5VJAA0018DW003852 AND BELOW
FITS MODELS: SC3265, SC3305, SC3305E & SC3342 (SC3206 is excluded)
SUPPLEMENTAL ADAPTER KIT 77438-00 is required for this Trailer VIN range if the machine is Se-
rial #
2
2
3
4
5
6 7
8
9
3
1
ATTACH WHEELS (FIGURE 1)
1. Attach wheels to trailer using 3/4"-16 slotted nuts
(1), washers, 5/32" cotter pins (2) and dust caps
(3). Using 3/4" wrench, tighten slotted nut until
resistance is felt when trying to spin wheel. At that
point, back the nut off slightly until slot in nut aligns
with cotter pin hole on axle spindle.
2. Insert cotter pin, bend tabs to secure slotted nut
on spindle and install dust cap.
TRAILER ASSEMBLY INSTRUCTIONS
(FIGURE 2)
1. Place hitch pole (1) into trailer frame. Route trailer
light harness through the two provided coated clamps
(2). (Extend trailer leg for more stability while securing
hitch.)
1
2
3
Figure 1
Figure 2
2. Now, secure hitch pole to frame using one 3/8 x 3-1/4"
bolt (3), coated clamp, washer and nut at the hole
location detailed in Figure 2 Torque to 28 ft-lbs. Place
3/8" hitch pin (4) in 3/8" hole closest to the trailer.
Also see Figure 2 for location details. This pin can be
removed to allow the hitch to be positioned vertically
for storage purposes. Reinstall pin once the hitch is in
the vertical position.
3. Attach the remaining coated harness clamp (with
harness already routed through it) to hitch pole using
5/16 x 2-3/4" hex bolt (5), washer and nylock nut.
4. Now attach the 2" coupler (6) to the end of the hitch
pole opposite the trailer. Use two 1/2 x 3" bolts (7) and
centerlock nuts.
5. Secure the safety chains (8) to the hitch pole at the
second open hole location behind the coupler. Use the
3/8 x 3-1/4" bolt (3), two washers and one nylock nut.