DNF Controls DMAT-EZ - Manual (Page 7)

DMAT-EZ, Instant Replay Controller Page 7 of 26
B. Connections
1. Using standard 9-conductor (pin to pin), RS422 serial cable,
follow the connection diagram to connect the controller to the
server. Identify your chassis by comparing the "C" number on
the serial number tag to the illustration number.
Note: On the 22 model:
Only connectors 1, 2, 4, and 5 are available on C1xx3xx chassis.
Only connectors 1, 2, 3, and 4 are available on C1xx4xx chassis.
2. Attach a video reference cable (from House Reference) to "Ref.
Video In" on the rear of the ST400 to utilize the gang function.
Video Reference must be connected for frame accurate playout of
ganged channels.
3. Connect the supplied POWER SUPPLY, APX #4108, into the
POWER connector on the rear of the ST400. Plug the Power
Supply into a 90 - 240 VAC outlet.
4. Check SETUP MENU prior to using the ST400 to confirm proper
Record Mode and other User Settable Modes.
Installation is complete.
C. Video Server Setup
1. Select control protocol according to DMAT-EZ model:
a) For the O model, Select ODETICS protocol on each VIDEO
SERVER channel to be controlled.
b) For the A Model, Select AMP protocol on each VIDEO SERVER
channel to be controlled.
2. Assign the serial ports on the VIDEO SERVER that will be
controlled by the ST400.