DNF Controls DMAT-EZ - Manual (Page 15)

DMAT-EZ, Instant Replay Controller Page 15 of 26
E. Playback
The playback may be in three modes: EE mode, PB mode and PL
mode. Playback of pre-recorded clips is available in the PB Mode.
1. EE Mode
NOTE: Press the [GANG] key to apply the following functions to
several VTRs (see SECTION B for details):
To put the channel into EE mode, press [REC] key. The Master Clip
will be loaded (DNF_REC1x on playback channel 1, DNF_REC2x on
playback channel 2 etc.), will search to the recorder’s timecode minus
Input Video Delay, and continue to play. The timecode that is
displayed on the first line of the display shows the recorder’s LTC. The
playback channel is also put into EE mode.
In EE mode, the user can mark IN and OUT points. The timecode for
the IN and OUT points is read from the Recorder. The user can also
perform non-transport functions (such as edit the playlist). Any
transport function will terminate the EE mode.
2. PB Mode
NOTE: Press the [GANG] key to apply the following functions to
several VTRs (see SECTION B for details):
Press any transport key to go from EE mode to PB mode. The CUEs
that were made in EE Mode can be GOTOed in PB mode.
NOTE: Pre-recorded clips can be loaded using the [CLIPLIST] button
to access and load the clip from the server. In and out points can be
set on these clips and entered as CUES. They will perform as any of
the other clips marked from the record clips.
If the [GOTO] key is pressed, the currently displayed IN point is cued
to.
Press the [PLAY ] key to play from the IN point to the OUT point and
stop. If the channel is parked at or after the OUT point, the playout
continues to play after the OUT point.
If IN and OUT points are marked, press the [LOOP] key to start play
of same clip after the OUT point.
The [GOTO LIVE] key will search the playback channel to the
recorder’s timecode minus Input Video Delay and continue to play.
The mode will be switched to PB. The user can mark IN and OUT
points in PB mode. In that case the IN and OUT times are read from
the Playback channel. The user can edit the playlist in PB mode. All
transport functions are available in PB mode.
When the channel plays out from IN to OUT point, it will display the
real-time countdown of the clip. (RT, the Real-Time Countdown is
displayed only when both IN and OUT points exist and the CUE plays).
Press the [RECUE] key to cue the loaded clip back to the IN point.