DNF Controls 3040P-DLO-L - Manual (Page 20)

Page 16 of 35 Model 3040P/DLO
2) RECORDING A LIST
a) Select Input Louth Port in the Menu.
b) Follow the same steps as in the previous section to record clips at their
trigger times.
NOTE: 1) There should be at least 5 seconds interval between the elements so
they don’t get down-cut.
2) The elements should be of record type or they will be skipped.
b. SEMI-AUTOMATIC PLAYOUT
Semi-automatic Playout mode is back to back playout of Hard Trigger and Follow Along
playlist elements. The LTC Input signal is not used.
Playout begins at the currently selected element. When this element completes playout,
the next element in the list is automatically played out. This process continues until a
BREAK or UNKNOWN element type is reached, or the end of the playlist is reached.
1) Confirm that Reference Video is connected to the REF VID IN connector on the
rear of the 3040P/DLO. The REF indicator, on the display, to the right of the
LTC Input time, will be on and NOT flashing. If the REF indicator is flashing,
reference video is missing. Semi-Automatic Playout will not operate.
2) Select channel by pressing VTR key “1”, “2”, “3”, or “4”.
3) In the Setup Menu, set Delete Mode= ON or OFF. If Delete Mode= ON, enter
the number of elements to keep after playout. Refer to Section 6h for more
information.
4) If the channel’s playlist is empty, download a playlist into this channel (Section
10) or manually enter a playlist using the EDIT functions (Section 12).
5) Use the [TOP], [NEXT], [LAST], [SHIFT] + [NEXT], [SHIFT] + [LAST],
[ALT] + [NEXT], or [ALT] + [LAST] keys to select the first element to
playout.
6) Press [SEMI AUTO] to enable this playout mode. The SEMI AUTO LED will
turn on.
7) Press [PLAY] to begin playout.
At anytime, press [STOP] to terminate playout.
At anytime, press [SHIFT] + [SEMI AUTO] to disable Semi-Automatic
Playout Mode. The SEMI AUTO LED will turn off.