Comtech EF Data PCB-4300 - Manual (Page 84)

PCB-4300 1:2 Phase Combiner Revision 2
Appendix B MN/PCB4300.IOM
B–6
B.5.6 Optional Message Arguments
Arguments are not required for all messages. Arguments are ASCII codes for the characters 0 to 9 (ASCII codes 48 to 57), period (ASCII
code 46) and comma (ASCII code 44).
B.5.7 End Of Packet
Controller-to-Target: This is the ‘Carriage Return’ character (ASCII code 13).
Target-to-Controller: This is the two-character sequence ‘Carriage Return’, ‘Line Feed’ (ASCII codes 13 and 10).
Both indicate the valid termination of a packet.
B.6 Remote Commands / Queries
Index Notes: Column ‘C’ = Command; Column ‘Q’ = Query; columns marked ‘X’ designate instruction code as Command only, Query only, or Command/Query.
CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE
A D P S
AGI X B-7 DAT X X B-8 PRF X X B-9 SBR X X B-11
AMP X X B-7 SFS X B-11
AOF X X B-7 SPA X X B-11
ATT X X B-7 F R
FRC X X B-8 RAS X B-10 T
FRW X B-9 RCS X B-10 TIM X X B-11
C RET X B-10 TNA X B-12
CAA X B-7 L RMS X B-11
CAS X B-7 LNA X B-9 RSN X B-11
CCS X B-8 RUS X B-11
CID X X B-8
CMS X B-8 M
CUS X B-8 MUT X X B-9
Unless otherwise noted – In the tables that follow, these codes are used in the ‘Response to Command’ column (per Sect. B.5.6)
= Message ok
? Received ok, but invalid arguments were found
* Message ok, but not permitted in current mode