Comtech EF Data PCB-4300 User Manual
Page 46
PCB-4300 1:2 Phase Combiner
Revision 2
Flash Upgrading
MN/PCB4300.IOM
4–4
Step Procedure
3
Double-click FLSHCAT.EXE
(filename or icon) to execute the
flash upload utility.
4
Front the FLSHCAT dialogue
box, select the pertinent serial
port used for communication
between the PC and the PCCB..
(In this example, as noted at ‘A’,
COM1 has been selected.)
5
Do not select a Baud Rate
(noted at ‘B’) other than the
default selection of 38400,
unless otherwise instructed by
Comtech EF Data Technical
Support.
6
Click on ‘Software Upload’ as
noted at ‘C’.
7
Select the firmware file for
upload.
Click ‘Choose File’ then, once
the Select a File Name dialogue
box opens, use the window on
the right to navigate to the
desired folder. Finally, double-
click on the firmware file from
the window on the left.
8
Prior to continuing the upload
process, the PCB-4300 system
must be powered off by
disconnecting the SSPA COM 1
J2, SSPA COM 2 J3, and
SSPA COM 3 J4 connector
cables.
Once this is done, click ‘Start
Upload’.